114
Chapter 4 PLAY Mode
SAMPLE Function
SAMPLE - SmpBnk (Select Sample from Sample Bank)
Selects a sample from a sample bank.
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Turn Knob 1 to select SmpSel.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action ✔✔✔✔ -
Push action ✔ - ✔✔✔
Use this page to remove a sample from a sample bank, or to edit the selected sample’s
name.
Knob 1 Change Page Select P/S
• Turn the knob to change to a different page within the SAMPLE function. Available
pages are: SmpSel, SmpBank, (this page), ToBank, and SmpSort.
• Push the knob to move to the Program/Sample Selection screen. (☞95)
Knob 2 Sample bank = bank name
• Turn this knob to select the sample bank containing the sample that you want to
remove or edit.
• If you select a new or edited sample bank that has not yet been saved to disk in its
current form, an [E] (“edited”) mark appears in front of the name.
Knobs 3, 4
Sample = sample name Edit the Name
• Turn either knob to select a sample from the sample bank selected by Knob 2.
• If you wish to set or change the name of the selected sample, push either knob to
proceed to the name-editing screen. For information about how to edit name strings,
see “Entering Names” (☞88).
Knob 5 >REMOVE
Push this knob to remove the sample from the sample bank. You will then be able to use
it as a freestanding sample.
To Next Page
Loading...
Need help?
General
