112
Chapter 4 PLAY Mode
SAMPLE Function
SAMPLE Function
This section describes the PLAY-mode SAMPLE function. You can use this function to
assign samples to programs, to save samples to disk, and to build sample banks.
SAMPLE - SmpSel (Select Sample)
Selects sample (or sample bank) for playback or editing, or saves data to disk.
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Turn Knob 1 to select SmpSel.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action ✔✔✔✔ -
Push action ✔✔✔ - ✔
Use this page to assign samples to the current program, to select samples for editing, or
to save the selected sample to disk.
Knob 1 Change Page Select P/S
• Turn the knob to change to a different page within the SAMPLE function. Available
pages are: SmpSel (this page), SmpBank, ToBank, and SmpSort.
• Push the knob to move to the Program/Sample Selection screen. (☞95)
Knobs 2, 3
Sample = sample name Edit the Name
• Turn either knob to select a sample (or sample bank) for program assignment or disk
save. Once you have selected the sample, you can use Knob 4 to assign it to (or de-
assign it from) the current program, and you can use Knob 5 to save it to disk.
If you select a sample bank, a [B] mark appears in front of the name. If you select a
stereo sample, an [S] mark appears in front of the name.
If you select a new or edited sample that has not yet been saved to disk in its current
form, an [E] (“edited”) mark appears to the right of the name.
• If you wish to set or change the sample name, push either knob to proceed to the
name-editing screen. For information about how to edit name strings, see “Entering
Names” (☞88).
To Next Page
Loading...
Need help?
General
