COMMAND Pages
158
Chapter 5 EDIT Mode
LOOPXFD (Loop Crossfade)
Sets up the loop crossfade for the sample.
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Press the COMMAND key, then turn Knob 1 to select >LOOPXFD.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action ✔✔✔ --
Push action ✔ ----
This command sets up a loop crossfade (overlapping fade-in and fade-out) so as to pro-
duce a smoother loop
Important
This command does not operate on sample banks.
Knob 1 Change Page >LOOPXFD
• Turn the knob to change to a different command page.
• Push the knob to register the crossfade. The A3000 returns a confirmation screen.
Push Knob 5 (>YES) to proceed, or Knob 4 (>NO) to cancel.
Knob 2: Width = 0%,...,100%
Sets the length of the crossfade area, as a percentage of the total loop length.
Knob 3 Area = sustain, release
Selects the area over which crossfade is applied, and determines the segments that are
used to generate the crossfade. (See the illustrations on the next page.)
sustain Generates the crossfade by merging the end part of the loop with
the area just preceding the loop start. This method produces
smoother sustained looping, and the crossfade recurs with each
iteration.
release Generates the crossfade by merging the initial part of the loop
with the initial segment following the loop area. This method
produces a smoother loop release, and the crossfade occurs only
once (as the loop is exited). This method is useful only with the
“– → – →” loop type (☞169).