268
Chapter 7 DISK Mode
DISK Function
DISK Function
You use the DISK function to select and manage disks (partitions). The A3000 uses the
disk that you select as the source for data loads. This selection also determines the
volumes that you can select at the VOLUME function (☞266).
You can also use this function to change the SCSI ID of the A3000, and to enable or
disable use of connected SCSI disks and CD-ROM drives.
Finally, you use this function’s command pages to format your disks (both hard disks
and floppies), and to create and manage disk partitions. You access the command pages
by selecting the DISK function, then pressing the COMMAND key (☞252 to 258).
For details about the relationship between disks, partitions, and volumes, refer to the
section entitled “Disks and Volumes” in Chapter 3. (☞81)
DISK - Disk
Selects a disk (partition).
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Turn Knob 1 to select Disk.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action ✔✔✔ --
Push action ✔✔✔ --
• Use this page to select the disk (partition) used for data loads, and to change the disk
(partition) name.
• The right side of the screen indicates the amount of free space on the currently se-
lected disk (partition).
FYI
If you find that you are unable to access a connected SCSI disk or CD-ROM, go to the
Configure page (☞270) to check the device’s SCSI ID and to make sure the device is
enabled (“mounted”).
To Next Page
Loading...
Need help?
General
