Yamaha A3000 User Manual

Installing an Internal Hard Disk
323
Appendix
Appendix
Installing an Internal Hard Disk
This section explains how to install a standard SCSI hard disk drive (bare drive) into the
A3000.
Important
• Before performing the installation, please read precautions “Handling and Installa-
tion of Options,” found at the beginning of this manual.
• Consult your Yamaha dealer for information about hard disk models that have been
confirmed as operating correctly with the A3000.
Procedure
1.
Be sure that you have the following at hand before starting the installation.
• A3000 main unit
• Internal SCSI hard disk
• Hard disk installation screws
Available from your hard disk dealer.
• Red/white cable (4-wire cable) supplied with the A3000. (power supply cable for the
hard disk)
• SCSI cable for the hard disk supplied with the A3000.
• Phillips screwdriver
Magnetic-tipped screwdriver is recommended.
• Screwdriver for the hard-disk installation screws.
Note that some hard-disk models do not use Phillips-head screws.
• Workbench
Please carry out all work on a stable workbench or table. Spreading a cloth over the
work surface will help prevent scratching.
• Gloves: Be sure to wear gloves so that your hands are not scratched by the metal
cover or other metal parts.

Yamaha A3000 Specifications

General

Sampling Rate	44.1kHz
MIDI	In/Out/Thru
Type	Sampler
Effects	Reverb, Chorus, Delay
Display	LCD
Storage	Floppy disk drive