Yamaha A3000 User Manual

187
Chapter 5 EDIT Mode
Chapter 5
FILTER Function
FILTER - EQ (Equalization)
Sets the sample’s equalization.
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Turn Knob 1 to select EQ.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action ✔✔✔✔ -
Push action ✔ ----
This page sets up the sample’s 1-band equalizer.
Knob 1 Change Page Select P/S
• Turn the knob to change to a different page within the FILTER function. Available
pages are: Filter, FltSens, FltScale, and EQ (this page).
• Push the knob to move to the Program/Sample Selection screen. (☞95)
Knob 2 Freq = 32Hz,...,16.0kHz
Turn the knob to set the equalizer’s frequency point.
Knob 3 Gain = -12dB,...,+12dB
This value sets the gain at the equalizer’s frequency point.
Knob 4 Width = 1.0,...,2.0
This value determines the width of the emphasis or attenuation band. Note that smaller
values increase the width, while larger values decrease the width.

Yamaha A3000 Specifications

General

Sampling Rate	44.1kHz
MIDI	In/Out/Thru
Type	Sampler
Effects	Reverb, Chorus, Delay
Display	LCD
Storage	Floppy disk drive