Yamaha A3000 User Manual

DISK Mode
249
Chapter 7 DISK Mode
Chapter 7
COMMAND Pages
This section describes the command screens (command pages) that you can access by pressing
the COMMAND key while working in DISK mode.
LOAD
Loads the selected disk-resident program into any program number in memory.
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Press the COMMAND key.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action --✔✔ -
Push action ✔ ----
Use this command when you want to load the selected disk-resident program into main
memory under a different program number. You can load the program into any pro-
gram number (001 to 128) on the memory side. The number at the disk side remains
unchanged.
Knob 1 >LOAD
Push the knob when you are ready to execute the load. The A3000 returns a confirma-
tion screen. Push Knob 5 (>YES) to proceed with the load, or Knob 4 (>NO) to cancel.
Knobs 3, 4 Program = 001,...,128
Turn either knob to select the destination program number (memory-side program
number). The bottom line of the screen displays the destination number.

Yamaha A3000 Specifications

General

Sampling Rate	44.1kHz
MIDI	In/Out/Thru
Type	Sampler
Effects	Reverb, Chorus, Delay
Display	LCD
Storage	Floppy disk drive