COMMAND Pages
250
Chapter 7 DISK Mode
DELETE
Deletes a sample, sequence, or volume from disk.
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Press the COMMAND key, then turn Knob 1 to select >DELETE.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action ✔ --✔✔
Push action ✔ ----
Use this command to delete a sample or sequence within the currently selected volume,
or to delete the entire volume. (The command’s operation depends on the function you
are working in: SAMPLE, SEQUENCE, or VOLUME.)
Important
• If you are deleting a volume, keep in mind that the deletion will cause loss of all
objects stored within that volume.
• Note that it is not possible to delete the volume on a floppy disk.
Knob 1 Change Page >DELETE
• Turn the knob to change to a different command page. (Only available if you are
working in the VOLUME function.)
• Push the knob when you are ready to delete the sample, sequence, or volume indi-
cated above Knob 4 and 5. The A3000 returns a confirmation screen. Push Knob 5
(>YES) to proceed with the deletion, or Knob 4 (>NO) to cancel.
Knobs 4, 5
Sample | Sequence | Volume = name
• Turn either knob to select the sample, sequence, or volume that you want to delete.
(Operation depends on the function you are currently working in: SAMPLE, SE-
QUENCE, or VOLUME.)
• Note that if you select a sample bank for deletion, the A3000 will delete the bank itself
but will not delete the samples contained in the bank.
To Next Page
Loading...
Need help?
General
