Yamaha A3000 - Chapter 1 Setting up Setting up

Setting Up
20
Chapter 1 Setting Up
Setting Up
This chapter explains how to set up your equipment and run a simple sound check.
Setup Sequence
This chapter takes you through each of the steps necessary to connect up your system.
Connecting the Power
Explains how to connect up the A3000’s power cord. (☞21)
Connecting the A3000 Outputs
Shows how to connect the A3000’s stereo and assignable outputs to external audio de-
vices. (☞22)
Connecting the Audio Inputs
Shows how to connect microphones and other input devices to the A3000. (☞25)
MIDI Connections
Introduces basic MIDI concepts, and shows how to connect up MIDI devices. (☞27)
Power ON/OFF
Explains the proper sequence for turning connected devices on and off. (☞30)
Sound Check
Takes you through a simple sound check, to confirm that your equipment is connected
correctly. (☞32)
Important
If you have purchased SIMM expansion memory, the AIEB1 expansion board, or an in-
ternal hard disk for your A3000, or if you need to connect up an external SCSI disk,
please be sure to install this equipment before going through the procedures given in
this manual. For installation and connection information, please refer to the following
pages.
• SIMM modules ☞312
• AIEB1 board ☞316
• Internal SCSI hard drive ☞326
• External SCSI drive ☞331