161
Chapter 5 EDIT Mode
Chapter 5
TRIM/LOOP Function
TRIM/LOOP Function
This section describes the EDIT mode’s TRIM/LOOP function. You use this function to
change the playback area on the waveform (the playback “start” and “end” points), to
trim off extraneous waveform data, to set the playback direction (forward or backward)
and loop characteristics (loop range and type), and to make various other related set-
tings.
FYI
Keep in mind that the COMMAND key gives you rapid access to a number of helpful
commands while you are working with this function. For example, you can use the
COMMAND key when you want to save your edit results to disk, or when you want to
cancel your new changes and restore the previously saved data. (☞147)
TRIM/LOOP - Config (Configure)
Selects TRIM/LOOP editing options.
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Turn Knob 1 to select Config.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action ✔✔✔✔✔
Push action ✔ ----
Use this page to select TRIM/LOOP edit options. You can choose to lock the waveform
playback and loop lengths, or you can enable automatic zeroing or automatic snap (see
below). You can also select the type of value used to indicate the sample’s end and loop-
end addresses.
Important
The Length, Zero, and Snap options are mutually exclusive: enabling any one of these
automatically disables the other two.
Knob 1 Change Page Select P/S
• Turn the knob to change to a different page within the TRIM/LOOP function. Avail-
able pages are: Config (this page), Wave, Loop, and WvMode.
• Push the knob to move to the Program/Sample Selection screen. (☞95)
To Next Page
Loading...
Need help?
General
