Yamaha A3000 User Manual

COMMAND Pages
284
Chapter 8 UTILITY Mode
SAVESYS (Save System Settings)
Saves system settings to disk.
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Press the COMMAND key, then turn Knob 1 to select >SAVESYS.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action ✔✔✔ --
Push action ✔ ----
Use this command when you want to save the current system environment (all system
settings) to disk. For a complete listing of the system parameters, refer to Table 2, “Sys-
tem Parameters,” in the “MIDI data format” section of the Appendix. (☞352)
Important
Each disk partition can store one environment only. Note that the environment is stored
at the disk level (rather than the volume level), and is not identified by name.
Knob 1 Change Page >SAVESYS
• Turn the knob to change to a different command page.
• Push the knob to execute the save. The A3000 returns a confirmation screen. Push
Knob 5 (>YES) to proceed, or Knob 4 (>NO) to cancel.
Knobs 2, 3 Disk = disk (partition) name
Turn either knob to select the destination disk (disk partition).

Yamaha A3000 Specifications

General

Sampling Rate	44.1kHz
MIDI	In/Out/Thru
Type	Sampler
Effects	Reverb, Chorus, Delay
Display	LCD
Storage	Floppy disk drive