COMMAND Pages
101
Chapter 4 PLAY Mode
Chapter 4
INIT (Program Initialization)
Use this command page to initialize one or all programs.
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Press the COMMAND key, then turn Knob 1 to select >INIT.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action ✔✔✔✔ -
Push action ✔ ----
Use this screen to initialize one or all memory-resident programs.
FYI
Initialization removes all sample assignments (sets all ToPgm switches to OFF), clears
all Easy Edit settings, and returns the EFFECT, SETUP, and CONTROL settings to the
initial values selected at the SETINIT page (☞104). (If you have not set any SETINIT
values, then EFFECT, SETUP, and CONTROL settings revert to their factory defaults)
Knob 1 Change Page >INIT
• Turn the knob to change to a different command page.
• Push the knob to execute program initialization. The A3000 then returns a confirma-
tion screen. Push Knob 5 (>YES) to complete the initialization, or Knob 4 (>NO) to
cancel.
Knob 2 Type of Initialization = Pgm, AllPgm
Turn the knob to select whether to initialize all programs or only one program.
Pgm Initialize only the program selected by Knob 3 or 4.
AllPgm Initialize all programs.
Knobs 3, 4
Program = 001,...,128
If you are initializing a single program only, turn either knob to select the program.
Note that this item does not appear if you are initializing all programs (if Type is set to
AllPgm).
To Next Page
Loading...
Need help?
General
