264
Chapter 7 DISK Mode
SEQUENCE Function
SEQUENCE Function
You use the SEQUENCE function to load one or all sequences from a floppy disk or SCSI
disk volume into the A3000 main memory. Before using this function, you must select
the source disk or volume using the DISK or VOLUME function.
• If loading from a floppy disk, you must first insert the floppy disk into the A3000
floppy drive, and then select the disk at the DISK function. (☞268)
• If loading from a SCSI disk, you must first select the disk (partition) and volume
containing the sequence(s) you want to load. (☞268, 266)
For details about the relationship between disks, partitions, and volumes, refer to the
section entitled “Disks and Volumes” in Chapter 3. (☞81)
FYI
Before you can load sequences, you must first save them to disk. You can save your
sequence(s) to disk using the UTILITY | SEQUENCE function. (☞281)
SEQUENCE - SeqLoad (Load Sequence(s))
Loads one or all sequences from disk.
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action - ✔✔ --
Push action ✔ --✔✔
Use this page to load one or all sequences from disk.
Knob 1 Select P/S
Push the knob to move to the Program/Sample Selection screen. (☞95)
Knobs 2, 3
Sequence = sequence name
If you want to load a single sequence from disk, turn this knob to select the disk-side
sequence.
To Next Page
Loading...
Need help?
General
