128
Chapter 4 PLAY Mode
SETUP Function
SETUP Function
The PLAY-mode SETUP function lets you set each program’s general output level, trans-
position, portamento, and A/D-input.
SETUP - PgmMstr (Program’s Master Settings)
Sets the program’s output level, transposition, and LFO “sample & hold” speed.
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Turn Knob 1 to select PgmMstr.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action ✔✔✔✔ -
Push action ✔ ----
Use this page to set the program’s overall output level, its transposition, and its sample/
hold speed.
Knob 1 Change Page Select P/S
• Turn the knob to change to a different page within the SETUP function. Available
pages are: PgmMstr (this page), Portmnt, ADSetup, and ADOut.
• Push the knob to move to the Program/Sample Selection screen. (☞95)
Knob 2 Level = 0,...,127
Turn the knob to set the program’s overall output level.
Knob 3 Transpose = -127,...,+127
Use this setting to transpose the program up or down, in semitone increments. The
transposition operates by raising or lowering all samples used by the program.
Note that each sample’s keyboard range also transposes by an equivalent amount. If a
sample’s keyboard range is set to C3 through B3, for example, then transposing the
program by -12 will shift the range for the sample to C2 through B2, so that striking key
C2 will produce the sound originally associated with key C3.
To Next Page
Loading...
Need help?
General
