Yamaha A3000 User Manual

192
Chapter 5 EDIT Mode
EG Function
EG - FEGRate (Filter-EG Rates)
Sets the rates for the filter EG.
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Turn Knob 1 to select FEGRate.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action ✔ - ✔✔✔
Push action ✔ ----
Use this page together with the FEGLevel page (☞194) to set up the sample’s FEG (filter
envelope generator). The FEG determines how the filter’s cutoff frequency shifts over
time as each note plays out.
Note On
Frequency (+)
Frequency (-)
Initial Level
Attack Rate Decay Rate Release Rate
Time
Attack Level
Release Level
Sustain Level
Specified Cutoff
Frequency*
Note Off
Use the FEGRate page (this page) to set the rates (attack, decay, and release rates). Use
the FEGLevel page to set the levels (initial, attack, sustain, and release levels).
* “Specified Cutoff Frequency” is the value set by the Cutoff parameter on the Filter
page (☞182).

Yamaha A3000 Specifications

General

Sampling Rate	44.1kHz
MIDI	In/Out/Thru
Type	Sampler
Effects	Reverb, Chorus, Delay
Display	LCD
Storage	Floppy disk drive