191
Chapter 5 EDIT Mode
Chapter 5
EG Function
Knob 4 AttackMode = rate, hold
This value sets the AEG attack mode — the way that amplitude behaves immediately
following Note On.
rate Level starts at 0 (when Note On occurs) and rises to maximum,
then begins to drop.
hold Level starts immediately at it maximum point and holds steady
for a certain interval before beginning to drop.
Note that the AtkRate setting on the AEG page (☞188) sets the timing for the attack.
Higher AtkRate settings produce a faster attack — so that the level rises more quickly (if
the mode is set to rate) or holds steady for a shorter time before dropping (if the mode is
set to hold).
Note On
If AttackMode = rate:
Level
Maximum Level
Attack Rate
Time
Note Off Note On
If AttackMode = hold:
Level
Maximum Level
Attack Rate
Time
Note Off
To Next Page
Loading...
Need help?
General
