193
Chapter 5 EDIT Mode
Chapter 5
EG Function
Important
Filter-EG settings are not effective if the Type parameter on the Filter page (☞182) is set
to Bypass.
Knob 1 Change Page Select P/S
• Turn the knob to change to a different page within the EG function. Available pages
are: AEG, AEGMode, FEGRate(this page), FEGLevel, FEGMode, PEGRate, PEGLevel,
and PEGMode.
• Push the knob to move to the Program/Sample Selection screen. (☞95)
Knob 3 Attack = 0,...,127
This value sets the rate at which the cutoff frequency moves from its initial level (at
Note On) to the attack level. Higher values produce faster rates.
Knob 4 Decay = 0,...,127
This value sets the rate at which the cutoff frequency moves from the attack level to the
sustain level. Higher values produce faster rates.
Knob 5 Release = 0,...,127
This value sets the rate at which the cutoff frequency moves from the sustain level to the
release level following Note Off. Higher values produce faster rates.
Note that the effectiveness of this setting declines at higher AEG release rates (☞189),
since the sound dies out before the shift in cutoff frequency can be heard.
To Next Page
Loading...
Need help?
General
