116
Chapter 4 PLAY Mode
SAMPLE Function
Knob 5 >ADD
• Push this knob to add the selected sample to the selected sample bank.
• It is not possible to add a sample that is already assigned to a different sample bank or
to a program. If you select a sample that is already assigned, therefore, the A3000 will
display a Duplicate & Add? prompt screen — giving you a chance to generate a new
copy of the sample for inclusion into the selected bank.
The Duplicate & Add? screen also shows the default name for the new sample, which
is equivalent to original name + “*”. If you wish to change the name, press Knob 2 or
3 to proceed to the name-editing screen.
When you are ready to proceed, press Knob 5 (>YES) to generate the duplicate sam-
ple and add it to the selected sample bank.
Note that the A3000 does not create another copy of the waveform data when “dupli-
cating” the sample. Instead, both samples access the same waveform memory area.
This means that the duplication does not consume any additional waveform memory.
To Next Page
Loading...
Need help?
General
