120
Chapter 4 PLAY Mode
EASY EDIT Function
Poly/Mono Poly/Mono switch 174
Poramento Portamento on/off 174
AlternateGrp “Alternate group” select 208
Main Output Main Output select 176
Main Out level Output level to main output 176
Assign Output Assignable-output select 176
Assign Out Lvl Output level to assignable output 176
MIDI ReceiveCH MIDI Receive Channel 208
MIDI Control MIDI Control enable/disable‡ 210
* You can use these settings only to reduce the sample’s internally-set key range. Set-
tings that would increase the internally-set key range are ineffective. (See next page.)
† You can use these settings only to reduce the sample’s internally-set velocity range.
Settings that would increase this velocity range are ineffective. (See next page.)
‡ Selects whether the sample’s own control settings are effective or ineffective.
Knobs 4, 5
Value = parameter value
Turn either of these knobs to set the value for the selected parameter. Available values
differ for each parameter.
• Values preceded by a + or - sign are applied as offsets to the sample’s own setting. The
applied value (sample setting plus offset) is indicated in parentheses to the right of
the offset value.
• If you set the value to =Sample, the program will use the sample’s own setting.
• The Key Limit and Velocity Limit settings can be used only to reduce the sample’s
locally set keyboard range and velocity range. You cannot set the Limit Low value
below the sample’s own low-limit setting; you cannot set the Limit High value above
the sample’s high-limit setting. For example, if the sample’s locally set key range is
“C2 to B3”, then you may adjust the range to “C2 to B2,” but not to “C2 to B4.”
To Next Page
Loading...
Need help?
General
