Yamaha A3000 - Page 199

197
Chapter 5 EDIT Mode
Chapter 5
EG Function
Knob 4 →AtkLvl = -63,...,+63
This parameter sets the first velocity-sensitivity value for the FEG’s initial level and
attack level. The value operates together with the value set by Knob 5 to determine the
amount by which these levels vary in response to the velocity of the played note.
Positive settings cause levels to increase as velocity increases, while negative settings
cause levels to decrease as velocity increases.
Knob 5 →Level = -63,...,+63
This parameter sets the general velocity sensitivity for all FEG levels (initial, attack,
sustain, and release). Positive settings cause levels to increase as velocity increases,
while negative settings cause levels to decrease as velocity increases.