262
Chapter 7 DISK Mode
SAMPLE Function
Knob 1 Select P/S
Push the knob to move to the Program/Sample Selection screen. (☞95)
Knobs 2, 3
Sample = sample name
If you want to load a single sample from disk, turn either knob to select the disk-side
sample.
If you select a sample bank, a [B] appears in front of the name. (Stereo samples are not
identified by an [S] mark, however.)
Knob 4 >LOAD
• Push this knob to load the sample selected by Knob 2 or 3. The screen returns a
confirmation screen. Push Knob 5 (>YES) to execute the load, or Knob 4 (>NO) to
cancel.
• If the selected disk-side sample has the same name as a sample currently in memory,
the A3000 will prompt for instructions about how to resolve the conflict. (☞263)
Knob 5 >ALL
• Push this knob to load all samples from the selected disk volume. The A3000 returns
a confirmation screen. Push Knob 5 (>YES) to proceed, or Knob 4 (>NO) to cancel.
• If any of the disk-side samples has the same name as a sample in memory, the A3000
will prompt for instructions about how to resolve the conflict. (☞263)
To Next Page
Loading...
