Troubleshooting
349
Appendix
Appendix
Pitch is incorrect
• Has the pitch bend wheel of an external MIDI device been moved?
When there is a problem with the program settings
• Is Transpose set to a value other than 0? (☞128)
• If you are using a sample for which portamento is turned on, is the portamento Rate
set extremely low (or is the Time extremely high)? (☞130)
When there is a problem with the sample settings
• Is OrigKey set correctly? (☞170)
• Are Coarse and Fine set correctly? (☞178)
• Is Fixed turned ON? (☞178)
• Is Random set to a setting other than 0? (☞178)
• Is the PEG set? (☞198)
• If an external controller has been set to control the Pitch Bias of a sample, is that
controller raised (or lowered) ? (☞210)
When there is a problem with the utility settings
• Are the master tuning parameters Coarse and Fine set correctly? (☞298)
• Is the MIDI parameter Transpose set to other than 0? (☞307)
Cannot record
• If you are recording an analog signal, is the REC VOL knob turned up? (☞8)
• Is there free memory? To create contiguous free space, execute the Optimize opera-
tion. (☞223)
• Is the Input selected correctly? (☞227)
Cannot save data
• Is the write protect tab of the floppy disk in the Protect position?
• Is the floppy disk or hard disk formatted correctly? (☞252—258)
• Is the hard disk mounted correctly? (☞270)
• If you are using a hard disk, is a volume selected? (☞266)
To Next Page
