5 SUPPLEMENT
5-62
Tool radius compensation, tool tip point control, inclined-plane machining, and fixed
cycle must be selected and cancelled under the modal condition of workpiece setup
error correction (between G54.4Pp and G54.4P0), as shown in the example below for
the use of tool radius compensation.
Do not give any tool change command in the mode of workpiece setup error
correction.
Workpiece setup error correction is not available if the C-axis control of the turning
spindle No. 2 is concerned.
Do not enter a block of motion command which requires an angular movement
through more than 180°
See “D. Combination of workpiece setup error correction (G54.4) and other function”
in “5-3 Restriction of Combination”.
Serial No. 294060
Copyright (c) 2013 YAMAZAKI MAZAK CORPORATION. All rights reserved.
To Next Page
Loading...
Need help?
General
