SUPPLEMENT 5
5-81
D. Combination of workpiece setup error correction (G54.4) and other function
The table below shows the modes in which workpiece setup error correction (G54.4) is
selectable and the selectable code in workpiece setup error correction.
: Selectable, -: Not selectable
G54.4 commanded
in leftward code
mode
Leftward code
commanded in
G54.4 mode.
Circular interpolation (CW)
Circular interpolation (CCW)
High-speed machining mode ON
High-speed machining mode OFF
Cylindrical Interpolation
Polar coordinate interpolation ON
Polar coordinate interpolation OFF
Return to Second Reference Point
Thread cutting (straight, taper)
Nose radius/Tool radius compensation OFF
Nose radius/Tool radius compensation (left)
Tool radius compensation for five-axis machining (left)
Nose radius/Tool radius compensation (right)
Tool radius compensation for five-axis machining (right)
Tool length offset in tool-axis direction
Tool tip point control (Type 1) ON
Tool tip point control (Type 2) ON
Coordinate system setting/Spindle speed range setting
Selection of machine coordinate system
Tool-axis direction control
Selection of workpiece coordinate system 1
Workpiece setup error correction
Selection of workpiece coordinate system 2
Selection of workpiece coordinate system 3
Selection of workpiece coordinate system 4
Selection of workpiece coordinate system 5
Selection of workpiece coordinate system 6
Selection of additional workpiece coordinate systems
High-accuracy mode (Geometry compensation)
3-D coordinate conversion ON
3-D coordinate conversion OFF
Inclined-plane machining ON
Inclined-plane machining (by specifying tool-axis
Serial No. 294060
Copyright (c) 2013 YAMAZAKI MAZAK CORPORATION. All rights reserved.
To Next Page
Loading...
Need help?
General
