YAMAZAKI MAZAK VORTEX i Series User Manual

2 MACHINE INFORMATION
2-16
3. INTEGREX i-ST
[min
-1
]
Machine specification
Spindle No. 1
Spindle No. 2
Mill Spindle
(12000min
-1
)
Standard
Mill Spindle
(20000min
-1
)
Option
i-100ST
-
35 to 6000
35 to 6000
35 to 12000
35 to 20000
i-100BARTAC-ST
-
35 to 2000
i-200ST
1500U
35 to 5000
35 to 5000
i-300ST
1500U
35 to 4000
35 to 4000
i-400ST
1500U
35 to 3300
35 to 3300
Machine specification
Lower turret (Note)
i-100ST
-
35 to 6000
i-100BARTAC-ST
-
i-200ST
1500U
i-300ST
1500U
i-400ST
1500U
Note: Only turret for milling (option).
Remark: 3000 min
-1
is upper limit value during tapping cycle.
4. INTEGREX e-H
[min
-1
]
Machine specification
Spindle No. 1
Standard
Spindle No. 1
Option
Mill Spindle
(12000min
-1
)
Standard
Mill Spindle
(20000min
-1
)
Option
e-420H
1500U
35 to 4000
35 to 2500
35 to 12000
-
3000U
e-500H
1500U
35 to 3300
35 to 1600
35 to 10000
3000U
4000U
e-670H
3000U
4 to 1600
3 to 1000
25 to 5000
4000U
6000U
e-800H
4000U
1 to 700
-
25 to 10000
6000U
8000U
Remark: 3000 min
-1
is upper limit value during tapping cycle.
* The data are value for the following specifications:
 e-420H : Spindle through hole diameter 91
 e-500H : Spindle through hole diameter 104
 e-670H : Spindle through hole diameter 170 (270 for e-670H6000U)
Serial No. 294060
Copyright (c) 2013 YAMAZAKI MAZAK CORPORATION. All rights reserved.
Serial No. 294060

YAMAZAKI MAZAK VORTEX i Series Specifications

General

Brand	YAMAZAKI MAZAK
Model	VORTEX i Series
Category	Computer Hardware
Language	English