NC COMMAND 3
3-5
Inclined-plane machining ON
Inclined-plane machining (by specifying tool-axis direction) ON
Inclined-plane machining OFF
Longitudinal roughing cycle
Transverse roughing cycle
Compound thread-cutting cycle
Fixed cycle A (Longitudinal turning cycle)
Fixed cycle B (Transverse turning cycle)
Fixed cycle (Chamfering cutter 1, CW)
Fixed cycle (Chamfering cutter 2, CCW)
Fixed cycle (High-speed deep-hole drilling)
Fixed cycle (Reverse tapping)
Fixed cycle (Back spot facing)
Fixed cycle (Back boring)
Constant surface speed control ON
Constant surface speed control OFF
Feed per minute (asynchronous)
Feed per revolution (synchronous)
Polar coordinate input ON
Polar coordinate input OFF
Selection between diameter and radius data input
Two-Process Control by One Program
Cross machining control ON
Cross machining control OFF
Function for selecting the cutting conditions
Serial No. 294060
Copyright (c) 2013 YAMAZAKI MAZAK CORPORATION. All rights reserved.
To Next Page
Loading...
Need help?
General
