3 NC COMMAND
3-6
Turning spindle synchronized rotation
(master: turning spindle No. 1, slave: turning spindle No. 2)
Turning spindle synchronized rotation
(master: turning spindle No. 2, slave: turning spindle No. 1)
Turning spindle synchronized rotation OFF
Turning spindle 1 Start of forward rotation
Turning spindle 1 Start of backward rotation
Turning spindle 1 Rotation stop
Turning spindle 2 Start of forward rotation
Turning spindle 2 Start of backward rotation
Turning spindle 2 Rotation stop
Start of forward milling spindle rotation
Start of backward milling spindle rotation
Stop of milling spindle rotation
Turning spindle 1 C-axis connect/Milling mode select
Turning spindle 1 C-axis disconnect/turning mode select
Turning spindle 2 C-axis connect/Milling mode select
Turning spindle 2 C-axis disconnect/turning mode select
Spindle speed attainment check
Milling spindle-through coolant ON
Milling spindle-through coolant OFF
Turning spindle 1 C-axis clamping
Turning spindle 1 C-axis unclamping
Turning spindle 1 Chuck open
Turning spindle 1 Chuck close
Turning spindle 2 Chuck open
Turning spindle 2 Chuck close
Select pallet No. 1 (optional) (INTE iV/eV)
Select pallet No. 2 (optional) (INTE iV/eV)
Select pallet No. 1 (optional) (INTE iV/eV)
Select pallet No. 2 (optional) (INTE iV/eV)
Serial No. 294060
Copyright (c) 2013 YAMAZAKI MAZAK CORPORATION. All rights reserved.
To Next Page
Loading...
Need help?
General
