Printer Configuration and Adjustment
110
Accepted values:
• SETTINGS—Prints a printer configuration label. (See CONFIG INFO TO
USB onpage119 for other ways to view this information.) A sample
label is shown in Figure 14 on page 111.
• NETWORK—Prints the settings for any print server or Bluetooth device
that is installed. A sample label is shown in Figure 15 on page 111.
• FORMATS—Prints the available formats stored in the printer’s RAM, Flash
memory, or optional memory card.
• IMAGES—Prints the available images stored in the printer’s RAM, Flash
memory, or optional memory card.
• FONTS—Prints the available fonts in the printer, including standard
printer fonts plus any optional fonts. Fonts may be stored in RAM or
Flash memory.
• BARCODES—Prints the available barcodes in the printer. Barcodes may
be stored in RAM or Flash memory.
• ALL—Prints the previous six labels.
• SENSOR PROFILE—Shows the sensor settings compared to actual
sensor readings. To interpret the results, see Sensor Profile
on page 226.
Related ZPL command(s):
SETTINGS: ~WC
NETWORK: ~WL
SENSOR PROFILE: ~JG
Others: ^WD
Control panel key(s):
SETTINGS and NETWORK: Do one of the following:
• Hold CANCEL during printer power-up. (Formerly called a CANCEL
self test.
• Hold FEED + CANCEL for 2 seconds when the printer is in the
Ready state.
SENSOR PROFILE: Hold FEED + CANCEL during printer power-up.
Printer web page: View and Modify Printer Settings > Print Listings on Label
To Next Page
Loading...