Routine Maintenance
199
Clean the Exterior, the Media Compartment, and the Sensors
Over time, dust, grime, and other debris may build up on the outside and inside of your printer, particularly
in a harsh operating environment.
Printer Exterior
You may clean the exterior surfaces of the printer with a lint-free cloth and a small amount of a mild
detergent, if necessary. Do not use harsh or abrasive cleaning agents or solvents.
Media Compartment and Sensors
1. Brush, air blow, or vacuum any accumulated paper lint and dust away from the media and ribbon
paths.
2. Brush, air blow, or vacuum any accumulated paper lint and dust away from the sensors.
Important • Zebra is not responsible for damage caused by the use of cleaning fluids on this printer.
1
Take-label sensor
2
Ribbon sensor
3
Media sensor
To Next Page
Loading...