Printer Configuration and Adjustment
115
TOOLS > LOAD DEFAULTS
Restore specific printer, print server, and network settings back to the factory defaults. Use care when
loading defaults because you will need to reload all settings that you changed manually. This menu item is
available through two user menus with different default values for each.
TOOLS
—
PRINT INFORMATION
—
IDLE DISPLAY
—
POWER UP ACTION
—
HEAD CLOSE ACTION
—
LOAD DEFAULTS
—
MEDIA/RIBBON CAL
—
DIAGNOSTIC MODE
—
ENERGY STAR
—
CONFIG INFO TO USB
—
ZBI ENABLED?
—
RUN ZBI PROGRAM
—
STOP ZBI PROGRAM
—
PRINT USB FILE
—
COPY USB FILE TO E:
—
STORE E: FILE TO USB
—
PRINT STATION
—
PASSWORD PROTECT
—
APPLCTR ERR: PAUSE
—
PRINT TEST FORMAT
Accepted values:
• FACTORY—Restores all printer settings other than the network settings
back to the factory defaults. Use care when loading defaults because
you will need to reload all settings that you changed manually.
• NETWORK—Reinitializes the printer’s wired or wireless print server. With
a wireless print server, the printer also reassociates with your wireless
network.
• LAST SAVED—Loads settings from the last permanent save.
Related ZPL command(s):
FACTORY: ^JUF
NETWORK: ^JUN
LAST SAVED: ^JUR
Control panel key(s): FACTORY: Hold FEED + PAUSE during printer power-up to reset the
printer parameters to factory values.
(Formerly called a FEED + PAUSE self test.)
NETWORK: Hold CANCEL + PAUSE during printer power-up to reset the
network parameters to factory values.
(Formerly called a CANCEL + PAUSE self test.)
LAST SAVED: N/A
Printer web page: FACTORY: View and Modify Printer Settings > Restore Default
Configuration
NETWORK: Print Server Settings > Reset Print Server
LAST SAVED: View and Modify Printer Settings > Restore Saved
Configuration
To Next Page
Loading...