Zebra ZT600 Series User Manual

Printer Configuration and Adjustment
152
RFID > RFID TEST
During the RFID test, the printer attempts to read and write to a transponder. No printer movement occurs
with this test.
To test an RFID label:
1. Position the RFID label with its transponder over the RFID antenna array.
2. Press RIGHT SELECT to select START.
The results of the test are shown on the display.
RFID
—
RFID STATUS
—
RFID CALIBRATE
—
READ RFID DATA
—
RFID TEST
—
RFID PROGRAM POS.
—
RFID ANTENNA
—
RFID READ POWER
—
RFID WRITE POWER
—
RFID VALID COUNT
—
RFID VOID COUNT
Accepted values: quick—Performs a read EPC test and a write EPC test (using random
data).
read—Performs a read EPC test.
write—Performs a write EPC test (using random data).
SGD command used:
rfid.tag.test.content and rfid.tag.test.execute

Zebra ZT600 Series Specifications

General

Print Method	Thermal Transfer/Direct Thermal
Print Resolution	203 dpi/8 dots per mm; 300 dpi/12 dots per mm
Maximum Print Width	4.09 in./104 mm
Maximum Print Speed	14 ips (356 mm/s) for 203 dpi, 12 ips (305 mm/s) for 300 dpi
Media Sensors	Reflective and Transmissive
Communication	USB, Serial, Ethernet, Bluetooth
Memory	512 MB Flash
Operating Temperature	5°C to 40°C