Zebra ZT600 Series - HEAD CLOSE ACTION

Printer Configuration and Adjustment
114
TOOLS > HEAD CLOSE ACTION
Set the action for the printer to take when you close the printhead.
Accepted values:
• CALIBRATE—Adjusts sensor levels and thresholds, determines the label
length, and feeds the media to the next web.
• FEED—Feeds the labels to the first registration point.
• LENGTH—Determines the label length using current sensor values, and
feeds the media to the next web.
• NO MOTION—Tells the printer not to move the media. You must manually
ensure that the web is positioned correctly, or press feed to position the
next web.
• SHORT CAL—Sets the media and web thresholds without adjusting
sensor gain, determines the label length, and feeds the media to the
next web.
Related ZPL command(s):
^MF
SGD command used:
ezpl.head_close_action
Printer web page: View and Modify Printer Settings > Calibration
TOOLS
—
PRINT INFORMATION
—
IDLE DISPLAY
—
POWER UP ACTION
—
HEAD CLOSE ACTION
—
LOAD DEFAULTS
—
MEDIA/RIBBON CAL
—
DIAGNOSTIC MODE
—
ENERGY STAR
—
CONFIG INFO TO USB
—
ZBI ENABLED?
—
RUN ZBI PROGRAM
—
STOP ZBI PROGRAM
—
PRINT USB FILE
—
COPY USB FILE TO E:
—
STORE E: FILE TO USB
—
PRINT STATION
—
PASSWORD PROTECT
—
APPLCTR ERR: PAUSE
—
PRINT TEST FORMAT