Printer Configuration and Adjustment
140
NETWORK > WLAN IP PROTOCOL
This parameter indicates if the user (permanent) or the server (dynamic) selects the wireless print server’s
IP address. When a dynamic option is chosen, this parameter tells the method(s) by which this print server
receives the IP address from the server. See IP Address Changing on page 245 for additional
information.
Important • You must reset the print server to allow changes to the network settings to take effect.
Accepted values:
• ALL
• GLEANING ONLY
• RARP
• BOOTP
• DHCP
• DHCP & BOOTP
• PERMANENT
Related ZPL command(s):
^ND
SGD command used: wlan.ip.protocol
Printer web page: View and Modify Printer Settings > Network Communications Setup >
Wireless Setup
NETWORK
—
ACTIVE PRINT SERVER
—
PRIMARY NETWORK
—
WIRED IP ADDRESS
—
WIRED SUBNET MASK
—
WIRED GATEWAY
—
WIRED IP PROTOCOL
—
WIRED MAC ADDRESS
—
WLAN IP ADDRESS
—
WLAN SUBNET MASK
—
WLAN GATEWAY
—
WLAN IP PROTOCOL
—
WLAN MAC ADDRESS
—
ESSID
—
CHANNEL
—
SIGNAL
—
IP PORT
—
IP ALTERNATE PORT
—
PRINT INFORMATION
—
RESET NETWORK
—
VISIBILITY AGENT
—
LOAD DEFAULTS
To Next Page
Loading...