Zebra ZT600 Series - LABEL SENSOR

Printer Configuration and Adjustment
168
SENSORS > LABEL SENSOR
Set the sensitivity of the label sensor.
Important • This value is set during sensor calibration. Do not change this setting unless you are told to
do so by Zebra Technical Support or by an authorized service technician.
Accepted values:
0 to 255
SGD command used:
ezpl.label_sensor
Printer web page: View and Modify Printer Settings > Calibration
SENSORS
—
SENSOR TYPE
—
MEDIA/RIBBON CAL
—
PRINT INFORMATION
—
SELF ADJUST SENSOR
—
LABEL SENSOR
—
TAKE LABEL