Zebra ZT600 Series User Manual

Specifications
262
Power Cord Specifications
Depending on how your printer was ordered, a power cord may or may not be included. If one is not
included or if the one included is not suitable for your requirements, see Figure 24 for specifications.
Figure 24 • Power Cord Specifications
Figure 25 • International Safety Organization Certification Symbols
Caution • For personnel and equipment safety, always use an approved three-conductor power cord
specific to the region or country intended for installation. This cord must use an IEC 320 female
connector and the appropriate region-specific, three-conductor grounded plug configuration.
1
AC power plug for your country—This should bear the certification mark of at least one of the
known international safety organizations (Figure 25). The chassis ground (earth) must be
connected to ensure safety and reduce electromagnetic interference.
2
3-conductor HAR cable or other cable approved for your country.
3
IEC 320 connector—This should bear the certification mark of at least one of the known
international safety organizations (Figure 25).
4
Length ≤ 9.8 ft. (3 m). Rating 10 Amp, 250 VAC.
3
1
2
4

Zebra ZT600 Series Specifications

General

Print Method	Thermal Transfer/Direct Thermal
Print Resolution	203 dpi/8 dots per mm; 300 dpi/12 dots per mm
Maximum Print Width	4.09 in./104 mm
Maximum Print Speed	14 ips (356 mm/s) for 203 dpi, 12 ips (305 mm/s) for 300 dpi
Media Sensors	Reflective and Transmissive
Communication	USB, Serial, Ethernet, Bluetooth
Memory	512 MB Flash
Operating Temperature	5°C to 40°C