Printer Configuration and Adjustment
94
SETTINGS > DARKNESS
Set the print darkness to the lowest setting that provides good print quality. If you set the darkness too
high, the label image may print unclearly, barcodes may not scan correctly, the ribbon may burn through,
or the printhead may wear prematurely.
If desired, use the Optimal Darkness and Speed Test on page 224 to determine the best darkness setting.
Accepted values:
0.0 to 30.0
Related ZPL command(s):
^MD, ~SD
SGD command used:
print.tone
Printer web page: View and Modify Printer Settings > General Setup > Darkness
SETTINGS
—
DARKNESS
—
PRINT SPEED
—
MEDIA TYPE
—
PRINT METHOD
—
TEAR OFF
—
PRINT WIDTH
—
PRINT MODE
—
LABEL TOP
—
LEFT POSITION
—
REPRINT MODE
—
LABEL LENGTH MAX
—
COVER OPEN LIGHT
—
MEDIA PATH LIGHTS
—
RIBBON PATH LIGHTS
—
LANGUAGE
To Next Page
Loading...