Printer Configuration and Adjustment
153
RFID > RFID PROGRAM POS.
If the desired programming position (read/write position) is not achieved through RFID tag calibration, a
value may be specified.
Accepted values: F0 to Fxxx (where xxx is the label length in millimeters or 999, whichever
is less)—The printer feeds the label forward for the specified
distance and then begins programming.
B0 to B30—The printer backfeeds the label for the specified distance and
then begins programming. To account for the backfeed, allow empty
media liner to extend out of the front of the printer when using a
backward programming position.
Related ZPL command(s):
^RS
SGD command used: rfid.position.program
Printer web page: View and Modify Printer Settings > RFID Setup > PROGRAM POSITION
RFID
—
RFID STATUS
—
RFID CALIBRATE
—
READ RFID DATA
—
RFID TEST
—
RFID PROGRAM POS.
—
RFID ANTENNA
—
RFID READ POWER
—
RFID WRITE POWER
—
RFID VALID COUNT
—
RFID VOID COUNT
To Next Page
Loading...