Zebra ZT600 Series - TAKE LABEL

Printer Configuration and Adjustment
169
SENSORS > TAKE LABEL
Set the intensity of the take label LED.
Important • This value is set during sensor calibration. Do not change this setting unless you are told to
do so by Zebra Technical Support or by an authorized service technician.
Accepted values:
0 to 255
SGD command used:
ezpl.take_label
Printer web page: View and Modify Printer Settings > Calibration
SENSORS
—
SENSOR TYPE
—
—
PRINT INFORMATION
—
SELF ADJUST SENSOR
—
LABEL SENSOR
—
TAKE LABEL