Zebra ZT600 Series - Exercise 5: Enter Data for a Stored File with a Smart Device and Print a Label

Using the USB Host Ports and the NFC Capabilities
258
Exercise 5: Enter Data for a Stored File with a Smart Device andPrintaLabel
1. If you do not have the Zebra Utilities app installed on your device, go to the app store for your device,
search for the Zebra Utilities app, and install it.
2. Pair your smart device with the printer by holding the smart device next to the NFC icon on the
printer.
a. If necessary, access the Bluetooth information about your printer using your smart device.
For instructions, refer to the manufacturer’s documentation for your device.
b. If necessary, select the Zebra printer’s serial number to pair it with the device.
c. After your smart device has been detected by the printer, the printer may prompt you to
accept or reject the pairing. If necessary, press the LEFT SELECT button on the printer to
select ACCEPT. Some smart devices will pair with the printer without this prompt.
The printer and your device are paired.
3. Start the Zebra Utilities app on your device.
The Zebra Utilities main menu displays.
Note • The steps in this exercise may vary somewhat based on your smart device, on your service
provider, or on whether you already have the free Zebra Utilities app installed on your smart device.
Refer to the
Zebra Bluetooth User Guide for specific instructions for configuring your printer to use a
Bluetooth interface. A copy of this manual is available at http://www.zebra.com/manuals.