Zebra ZT600 Series User Manual

Printer Configuration and Adjustment
99
SETTINGS > PRINT WIDTH
Specify the width of the labels being used, in dots. The default value is the maximum width for the printer,
based on the printhead’s DPI value.
Accepted values:
Note • Setting the width too narrow can result in portions of a label
format not being printed on the media. Setting the width too wide
wastes formatting memory and can cause the printer to print off of
the label and onto the platen roller. This setting can affect the
horizontal position of the label format if the image was inverted
using the ^POI ZPL II command.
ZT610 203 dpi = 0002 to 832
ZT610 300 dpi = 0002 to 1248
ZT610 600 dpi = 0002 to 2496
ZT620 203 dpi = 0002 to 1344
ZT620 300 dpi = 0002 to 1984
Related ZPL command(s):
^PW
SGD command used:
ezpl.print_width
Printer web page: View and Modify Printer Settings > Media Setup > Print Width
SETTINGS
—
DARKNESS
—
PRINT SPEED
—
MEDIA TYPE
—
PRINT METHOD
—
TEAR OFF
—
PRINT WIDTH
—
PRINT MODE
—
LABEL TOP
—
LEFT POSITION
—
REPRINT MODE
—
LABEL LENGTH MAX
—
COVER OPEN LIGHT
—
MEDIA PATH LIGHTS
—
RIBBON PATH LIGHTS
—
LANGUAGE

Zebra ZT600 Series Specifications

General

Print Method	Thermal Transfer/Direct Thermal
Print Resolution	203 dpi/8 dots per mm; 300 dpi/12 dots per mm
Maximum Print Width	4.09 in./104 mm
Maximum Print Speed	14 ips (356 mm/s) for 203 dpi, 12 ips (305 mm/s) for 300 dpi
Media Sensors	Reflective and Transmissive
Communication	USB, Serial, Ethernet, Bluetooth
Memory	512 MB Flash
Operating Temperature	5°C to 40°C