Printer Configuration and Adjustment
98
SETTINGS > TEAR OFF
If necessary, shift the position of the media over the tear-off bar after printing.
• Lower numbers move the media into the printer by the specified number of dots (the tear line moves
closer to the edge of the label just printed).
• Higher numbers move the media out of the printer (the tear line moves closer to the leading edge of
the next label).
Accepted values:
–120 to 120
Related ZPL command(s):
~TA
SGD command used:
ezpl.tear_off
Printer web page: View and Modify Printer Settings > General Setup > Tear Off
SETTINGS
—
DARKNESS
—
PRINT SPEED
—
MEDIA TYPE
—
PRINT METHOD
—
TEAR OFF
—
PRINT WIDTH
—
PRINT MODE
—
LABEL TOP
—
LEFT POSITION
—
REPRINT MODE
—
LABEL LENGTH MAX
—
COVER OPEN LIGHT
—
MEDIA PATH LIGHTS
—
RIBBON PATH LIGHTS
—
LANGUAGE
To Next Page
Loading...