Printer Configuration and Adjustment
161
LANGUAGE > COMMAND CHAR
The format command prefix is a two-digit hex value used as a parameter place marker in ZPL/ZPL II
format instructions. The printer looks for this hex character to indicate the start of a ZPL/ZPL II format
instruction.
Set the format command character to match what is used in your label formats.
Important • You cannot use the same hex value for the format command prefix, control character,
and delimiter characters. The printer must see different characters to work properly. If you are
setting the value through the control panel, the printer will skip any value that is already in use.
Accepted values: 00 to FF
Related ZPL command(s): ^CC or ~CC
SGD command used: zpl.caret
Printer web page: View and Modify Printer Settings > ZPL Control
LANGUAGE
—
LANGUAGE
—
COMMAND LANGUAGE
—
COMMAND CHAR
—
CONTROL CHAR
—
DELIMITER CHAR
—
ZPL MODE
—
VIRTUAL DEVICE
To Next Page
Loading...