Printer Configuration and Adjustment
138
NETWORK > WLAN SUBNET MASK
View and, if necessary, change the wireless subnet mask.
To save changes to this setting, set WLAN IP PROTOCOL on page 140 to PERMANENT, and then reset
the print server (see RESET NETWORK on page 147). See IP Address Changing on page 245 for
additional information.
Accepted values:
000 to 255 for each field
Related ZPL command(s):
^ND
SGD command used:
wlan.ip.netmask
Printer web page: View and Modify Printer Settings > Network Communications Setup >
Wireless Setup
NETWORK
—
ACTIVE PRINT SERVER
—
PRIMARY NETWORK
—
WIRED IP ADDRESS
—
WIRED SUBNET MASK
—
WIRED GATEWAY
—
WIRED IP PROTOCOL
—
WIRED MAC ADDRESS
—
WLAN IP ADDRESS
—
WLAN SUBNET MASK
—
WLAN GATEWAY
—
WLAN IP PROTOCOL
—
WLAN MAC ADDRESS
—
ESSID
—
CHANNEL
—
SIGNAL
—
IP PORT
—
IP ALTERNATE PORT
—
PRINT INFORMATION
—
RESET NETWORK
—
VISIBILITY AGENT
—
LOAD DEFAULTS
To Next Page
Loading...