Routine Maintenance
214
Replacing Printer Components
Some printer components, such as the printhead and platen roller, may wear out over time and can be
replaced easily. Regular cleaning may extend the life of some of these components. See Table 4
on page 198 for the recommended cleaning intervals.
Ordering Replacement Parts
The ZT600 Series printers are designed to work only with genuine Zebra ™ printheads, thus maximizing
safety and print quality.
Contact your authorized Zebra reseller for part ordering information.
Recycling Printer Components
Ordering Supplies
For optimal printing quality and proper printer performance across our product line, Zebra strongly
recommends the use of Zebra Certified Supplies as part of the total solution. A wide range of paper,
polypropylene, polyester, and vinyl stock has been specifically engineered to enhance the printing
capabilities of the printer and to prevent premature printhead wear. To purchase supplies, go to
http://www.zebra.com/supplies.
Lubrication
The only lubrication needed for this printer is for the cutter module. Follow the instructions in Clean and
Lubricate the Cutter Module onpage204. Do not lubricate any other parts of the printer.
The majority of this printer’s components are recyclable. The printer’s main logic board may include a
battery that you should dispose of properly.
Do not dispose of any printer components in unsorted municipal waste. Please dispose of the battery
according to your local regulations, and recycle the other printer components according to your local
standards. For more information, see http://www.zebra.com/environment.
Caution • Some commercially available lubricants will damage the finish and the mechanical parts if
used on this printer.
To Next Page
Loading...
Need help?
General