Printer Configuration and Adjustment
162
LANGUAGE > CONTROL CHAR
The printer looks for this two-digit hex character to indicate the start of a ZPL/ZPL II control instruction. Set
the control prefix character to match what is used in your label formats.
Accepted values: 00 to FF
Related ZPL command(s): ^CT or ~CT
SGD command used: zpl.control_character
Printer web page: View and Modify Printer Settings > ZPL Control
LANGUAGE
—
LANGUAGE
—
COMMAND LANGUAGE
—
COMMAND CHAR
—
CONTROL CHAR
—
DELIMITER CHAR
—
ZPL MODE
—
VIRTUAL DEVICE
To Next Page
Loading...