Zebra ZT600 Series - IP ALTERNATE PORT

To Next Page

To Previous Page

Printer Configuration and Adjustment

146

NETWORK > IP ALTERNATE PORT

This command sets the port number of the alternate TCP port.

Note • Print servers supporting this command will monitor both the primary port and the alternate port for

connections at the same time.

SGD command used: internal_wired.ip.port_alternate

Printer web page: View and Modify Printer Settings > Network Communications Setup >

TCP/IP Settings

NETWORK

—

ACTIVE PRINT SERVER

—

PRIMARY NETWORK

—

WIRED IP ADDRESS

—

WIRED SUBNET MASK

—

WIRED GATEWAY

—

WIRED IP PROTOCOL

—

WIRED MAC ADDRESS

—

WLAN IP ADDRESS

—

WLAN SUBNET MASK

—

WLAN GATEWAY

—

WLAN IP PROTOCOL

—

WLAN MAC ADDRESS

—

ESSID

—

CHANNEL

—

SIGNAL

—

IP PORT

—

IP ALTERNATE PORT

—

PRINT INFORMATION

—

RESET NETWORK

—

VISIBILITY AGENT

—

LOAD DEFAULTS

Zebra ZT600 Series - IP ALTERNATE PORT

Table of Contents

Other manuals for Zebra ZT600 Series