Zebra ZT600 Series - Page 227

Diagnostics and Troubleshooting
227
If you compare the sensor profile printout to a length of your media, the spikes should be the same
distance apart as the gaps on the media. If the distances are not the same, the printer may be having
difficulty determining where the gaps are located.
Figure 20 • Media Sensor Profile (Gap/Notch Media)
Figure 21 • Media Sensor Profile (Black Mark Media)
1
2
3
4
5
4
5
4
1
2
3
4
4
4
5
5
5
4
5