Printer Setup and Operation
23
7. Rotate the printhead-open lever downward until it locks the printhead in place.
8. Close the media door.
9. Set the printer to the appropriate print mode (see PRINT MODE on page 100).
10. Press PAUSE to exit pause mode and enable printing.
The printer may perform a label calibration or feed a label, depending on your settings.
11. For best results, calibrate the printer. See Calibrate the Ribbon and Media Sensors onpage181.
12. If desired, print a configuration or other label to verify that your printer is able to print. (See PRINT
INFORMATION on page 109.)
Media loading in Tear-Off mode is complete.
To Next Page
Loading...