Aastra Ascotel IntelliGate 2065 - Page 644

Ascotel IntelliGate 2025/2045/2065
644 Planning DECT systems Part 3
Fig. 3.39: Selection of the handover display for Look mode and Normal mode
&A
Show HO : Both
Ok
⇓
&A
Show HO : Disp
Ok
⇓
&A
Show HO : Beep
Ok
⇓
&A
Show HO : None
Ok
⇓
&A
Look Show HO
i M
1010 0 18 59
####
i M
1010 0 17 32
##
For look mode and normal mode a selection
can be made as to whether handovers are
to be displayed.
The beep setting specifies that each handover
is acoustically indicated by a beep tone:
high-pitched tone for connection HO to a new
radio unit, low-pitched tone for bearer HO to
the same radio unit.
The beep is output only in normal mode.
The "Disp" setting specifies that each handover
in normal mode is indicated on the display.
Before the HO:
The bar indicates that the signal
strength of the current radio unit
(No. 17) is bad and that HO should
be attempted.
HA attempts HO connection to a
new radio unit (No. 18).
After the HO:
The bar indicates that the signal strength
is very good. The new radio unit No. is
visible in the display (No. 18).
haz1303aaena0