Ascotel IntelliGate 2025/2045/2065
Part 3 Planning DECT systems 647
Procedure for an individual measurement
Display in Look-around mode
Fig. 3.43: Measure / Look-around
Selection of an individual radio unit to measure (display 1)
Fig. 3.44: Measure / Look-around state
Selection of the radio units to measure
Fig. 3.45: Measure / Tick
RFPI 0 17 65
go 1/7 ¥
haz0343aaxxb0
• Serial number of the system
• Number of the location area of PBX 0 in the test kit
• Field strength of the first selected radio unit channel [dBµV]
• Number of the radio unit
• Scroll through the radio units detected
• The top line shows the first of 7 detected radio units
• Measurement not yet running (press the Foxkey: RSSI values are no longer fro-
zen)
1015 0 17 65
1000101511
haz0348aaxxb0
• Serial number of the system
• Number of the location area of PBX 0
• Number of the radio unit
• Field strength of the best radio unit channel [dBµV]
• Hexadecimal representation of the full RFPI
tick.1/7 clr
haz0344aaxxa0
• This radio unit is already selected
• Press the Foxkey to select this radio unit (toggle)
To Next Page
Loading...
